Kantronics MT1200, Руководство пользователя

Страница: 101 / 157

count is exceeded while waiting for the connected station to acknowledge, the MT1200
moves to the disconnected state. Entering a second Disconnect command before
RETRY has expired will result in an immediate disconnect on your end, but may leave
the other station thinking it is still connected to you. Disconnect messages are not
displayed when the TNC is in Transparent Mode. Other commands may be entered
while the disconnect is in progress.
DISCONNE MYREM
Issue this command if you want to cause the remote access to issue a disconnect to the
user connected to the MYREMOTE callsign.
DISPLAY { A | C | G | I | L | M | T }
immediate
This command causes the TNC to display a list of all the parameters in the TNC. You
may also display only a selected group of parameters by specifying the appropriate
class identifier for that group. When using the DISPLAY command with a subclass be
sure to use a space between the DISPLAY command and the subclass. Subclasses of
related parameters are:
A SYNC asynchronous port parameters (TNC to computer)
C HAR special TNC characters
G PS parameters related to GPS operations
I D ID parameters
L INK parameters affecting packet link (TNC to TNC)
M ONITOR monitor parameters
T IMING timing parameters
Individual parameter values can be displayed by entering DISPLAY and the command
name, followed by “CR”.
See also: Display Listings section
DWAIT n (n = 0 - 255)
default 0
DWAIT defines a delay to be used to avoid collisions with digipeated packets. The value
entered for “n” is the number of 10 ms intervals, after last hearing data on the channel,
for the MT1200 to wait before it begins its own key-up sequence.
This value should be established and agreed on by all members of a local area network.
The best value will be determined by experimentation but will be a function of the key-
93