JVC VR-N1600E, Инструкция по эксплуатации

Страница: 30 / 136

22
Basic Operation
Switching the Power On
1
Connect the power cable
●
Connect the power cable to outlet.
2
Turn
A
ON
B
the power switch at the rear panel.
●
A system check will run when the power is turned on.
●
The [OPERATE] indicator starts blinking.
●
After blinking, the [OPERATE] indicator lights up to
indicate that operation has been turned on.
●
When the setting is complete, recording starts
automatically in the record control mode. (When
[Record Control] under [Unit Setting] of the main menu
is set to
A
ON at startup
B
.)
●
Note :
●
Do not disconnect the power cord nor turn the power
switch
A
OFF
B
while the system check is running or in the
OPERATE ON mode. Otherwise, it may break down.
Switching the Power Off
1
Press and hold the [OPERATE] button for about
2 seconds to turn the operation off
●
After blinking, the [OPERATE] indicator goes off.
2
Turn off the power switch on the rear panel
Note :
●
The recorded images may not be played back properly if
they are not archived (
A
Page 97) before the power
failure.
●
It is recommended that an uninterruptible power supply
(UPS) be used to protect the hard disk from damage in
the event of a power failure. (
A
Page 112)
Switching On/Off Using Operate Button on Front
Panel
You can switch operation to ON or OFF.
䡵
Switching Operation On
1
(When Operation is OFF) Press the [OPERATE]
button
●
The [OPERATE] indicator starts blinking.
●
The [OPERATE] indicator lights up, indicating that
operation is enabled.
Memo :
●
When the power switch on the rear panel is turned on, the
system starts up automatically until the OPERATE ON
mode is activated.
䡵
Switching Operation Off
1
(When operation is ON) Press and hold the
[OPERATE] button for about 2 seconds
●
The [OPERATE] indicator starts blinking.
●
The screen display disappears and the [OPERATE]
indicator goes off, indicating that operation has been
turned off.
Note :
●
Do not turn off the power until operation has been turned
off.
Switching On/Off Using Input/Output Terminal on
Rear Panel
For details on the layout of the input and output terminals on
the rear panel, refer to [Rear I/O Terminals] (
A
Page 11).
䡵
Switching Operation On
1
(When operation is OFF) Set the [OPE ON/OFF]
terminal to make for at least 50 ms
●
The [OPERATE] indicator starts blinking.
●
The [OPERATE] indicator lights up, indicating that
operation is enabled.
䡵
Switching Operation Off
1
(When operation is OFF) Set the [OPE ON/OFF]
terminal to make for at least 1 s
●
The [OPERATE] indicator starts blinking.
●
The screen display disappears and the [OPERATE]
indicator goes off, indicating that operation has been
turned off.
Note :
●
Do not turn off the power until operation has been turned
off.
Switching the Power On/
Off Switching Operation On/
Off
VR-N1600_J.book Page 22 Wednesday, August 8, 2007 3:32 PM