JVC GY-HM790U, Инструкция по эксплуатации

Страница: 51 / 144

47
Note :
●
When the [FULL AUTO] switch on the camera recorder is
set to
A
ON
B
, the recording level cannot be adjusted with
the [AUDIO LEVEL CH-1/CH-2] adjustment knob.
䡵
Automatic Adjustment Mode
Set the [AUDIO SELECT CH-1/CH-2] switch on the camera
recorder to
A
AUTO
B
or the [FULL AUTO] switch to
A
ON
B
to
enter Automatic Adjustment mode. The audio recording level
is set automatically according to the input level.
When the [FULL AUTO] switch is set to
A
ON
B
, mode
switching with the [AUDIO SELECT CH-1/CH-2] switch is
disabled.
Memo :
●
When [Audio] in the [Camera Function]
B
[FULL AUTO]
menu is set to
A
SW Set
B
, you can switch the recording
level mode with the [AUDIO SELECT CH-1/CH-2] switch
on the camera recorder even if the [FULL AUTO] switch is
set to
A
ON
B
. (
A
Page 81)
Audio Monitor During Recording
You can check the input audio with the monitor speaker or
earphones.
1
Select the channel to monitor with the
[MONITOR SELECT] switch.
2
Adjust the volume of the monitor audio with the
[MONITOR] adjustment knob.
Memo :
●
Alarm tone is output when there is an abnormality in the
camera recorder. Alarm tone is also output when the
SDHC card is full or when the battery is low.
(
A
Page 1 3 5)
●
Alarm tone is not output during recording.
Note :
●
Increasing the volume of the monitor too much may result
in howling of the camera microphone.
䡵
Using Stereo Type Earphone Jack
When a stereo type earphone jack is connected, perform the
following setting to output stereo sound.
1
Set the [MONITOR SELECT] switch to
A
BOTH
B
.
2
Set [Main Menu] B [A/V Out] B [Audio Monitor] to
A
Stereo
B
. ( A Page 9 3 )
Only audio from [CH-1] is output through the monitor
speaker.
Memo :
●
You can set the volume of the alarm tone with
[Alarm Level] in the [Main Menu]
B [Others] menu.
(
A
Off
B
/
A
Low
B
/
A
Middle
B
/
A
High
B
) (
A
Page 9 3 )
[CH-1] Outputs audio from [INPUT1] terminal.
[BOTH] Mixes and outputs audio from both [INPUT1/INPUT2]
terminals.
[CH-2] Outputs audio from [INPUT2] terminal.
[MONITOR]
Adjustment Knob
[MONITOR SELECT]
Switch
Monitor
Speaker
[PHONES]
Terminal