JVC GY-HM790U, Инструкция по эксплуатации

Страница: 127 / 144

123
[PHONES] Terminal
Audio output from the [PHONES] terminal can be selected
using [Audio Monitor] in the [A/V Out] menu (
A Page 9 3 ) as
well as the [MONITOR SELECT] switch on the camera
recorder.
The different combinations of settings that are output from
the [PHONES] terminal and monitor speaker are as follows.
“ Backup recording ” can be performed, which allows the
same image recorded to the SDHC card on the camera
recorder to be recorded to the external device connected to
the IEEE1
3 94 terminal. ( A Page 124)
Note :
●
When connecting the camera recorder to an external
device using an IEEE1
3 94 cable, make sure to observe
the following. Improper connection may cause the circuit
of the connected unit to malfunction.
●
Turn off the power of the camera recorder and
connected devices before connecting the IEEE1
3 94
cable.
●
Do not connect the cable in an environment where
static electricity occurs or is likely to occur.
●
Make sure that each camera recorder is connected to
only one external device at any one time.
●
When the video format input from the [IEEE1 3 94] terminal
is different from the video format of the camera recorder, a
A
VIDEO FORMAT INCORRECT
B
message is
displayed. Set according to the video format entered for
[System Definition], [Camera Resolution], and
[Frame & Bit Rate] in the [Record Format] menu.
(
A
Page 75)
●
If the [INT/EXT] IEEE1 3 94 interface terminal switch is set
at
A
EXT
B
and the
A
HQ
B
mode is selected in
[Frame & Bit Rate], signals will not be output from the
[IEEE1 3 94] terminal. ( A Page 75)
[MONITOR
SELECT]
Switch
Settings
[Audio Monitor]
Settings
[PHONES]
Terminal
Speaker
L R
[CH-1] ^ CH1 CH1
[BOTH] [Mix] CH1+CH2 CH1+CH2
[Stereo] CH1 CH2
[CH-2] ^ CH2 CH2
IEEE1 3 94 Connection
[IEEE1 3 94] Terminal
VIDEO FORMAT
INCORRECT