MNP37M03GBV00 Date: 24-11 Rev. 0
Page 45 of 79
This kit also includes 2 stainless steel springs at the outlets of each water softener
nozzle. These springs are there to prevent the silicon tubes that come out of the nozzles
from obstructing the points where the tubes bend.
5
3
6
4
3
7
1
2
8
Boquilla
entrada
Boquilla
salida
The steps to follow when installing a water softener kit in a JOFEMAR coffee machines
are as follows:
F
It is very important that, before installing the water softener in the machine,
the resin be rinsed once. To do this, connect the water softener inlet nozzle to a
faucet using the filter’s silicon tube. The water softener outlet nozzle is
connected to a waste container with another tube. Open the water softener
stopcocks and let water go through it for 15 minutes until the water is
completely colourless. After this, proceed as follows:
INSTALLING THE MACHINE
1. Disconnect the machine from electricity mains and empty the water circuit.
2. Place the water softener at the back of the machine, on the left-hand side (see
figure)
3. Remove the flexible tube connected to the machine inlet solenoid valve (
No. 8
)
(that goes to the air-break). This end of the tube (
No. 7
) is connected to the free
end of the flexible joint (
No. 6
).
4. Connect the free end of the silicone tube (
No. 2
) to the inlet solenoid valve.
5. Reconnect the machine to electricity mains so the water circuit can be filled again.
Содержание COFFEEMAR G-500 V2
Страница 1: ...MNP37M03GBV00 Date 24 11 Rev 0 Page 1 of 79 INGL S COFFEEMAR G 500 V2 USER S MANUAL...
Страница 26: ...MNP37M03GBV00 Date 24 11 Rev 0 Page 26 of 79 6 3 Electrical drawings Cabinet electrical drawing...
Страница 27: ...MNP37M03GBV00 Date 24 11 Rev 0 Page 27 of 79 Door electrical drawing...