JCM GLOBAL UBA Pro Series, Руководство по эксплуатации и обслуживанию

Страница: 67 / 132

P/N 960-000211R_Rev. A © 2020, JAPAN CASH MACHINE CO., LTD.
4 - 9
Disassembly/Reassembly UBA™ Pro Series Universal Banknote Acceptor Section 4
3. Unplug the two (2) Connectors (Figure 4-40 a
1
&
a
2
), and remove the FPC Harness (Figure 4-40 b ).
4. Remove the single (1) Screw (Figure 4-41 a ), and
remove the PDIC Array (Figure 4-41 b ).
Lower BAR Sensor Removal
To remove the Lower Bar Sensor, proceed as fol-
lows:
1. Remove the two (2) Screws (Figure 4-42 a
1
&
a
2
), and remove the Lower BAR Sensor (Figure
4-42 b ).
Slide Roller Removal
To remove the Slide Roller, proceed as follows:
1. Remove the Entrance Roller Shaft (Figure 4-43
a ).
2. Remove the Slide Roller Assy. (Figure 4-43 b ).
3. Disassemble the Slide Roller Assy. to remove the
Slide Rollers (Figure 4-44 a
1
& a
2
).
Figure 4-40 PDIC Array Removal 3
b
a
1
a
2
Figure 4-40 PDIC Array Removal 3
Figure 4-41 PDIC Array Removal 4
b
a
c
Figure 4-41 PDIC Array Removal 4
NOTE: Be careful not to drop the Prism
(Figure 4-41 c ) when disassembling.
NOTE: This removal procedure is reserved
for the UBA Pro Units equipped with a
Lower BAR Sensor Board.
Figure 4-42 Lower BAR Sensor Removal
b
a
1
a
2
c
Figure 4-42 Lower BAR Sensor Removal
NOTE: Be careful not to drop the Prism
(Figure 4-42 c ) when disassembling.
Figure 4-43 Slide Roller Removal 1
b
a
Wider
Narrower
Figure 4-43 Slide Roller Removal 1
NOTE: For the reassembly, ensure that the
Slid Roller Shaft Assy. is installed
considering its “Narrower” and “Wider” ends.
Figure 4-44 Slide Roller Removal 2
a
1
a
2
Figure 4-44 Slide Roller Removal 2