ITT Goulds Pumps XHD, Инструкция по установке, эксплуатации и обслуживанию

Страница: 44 / 160

Commissioning, Startup, Operation, and Shutdown
XHD Installation, Operation, and Maintenance Manual 42
4. Remove the driver half of the coupling guard:
a) Slightly spread the bottom apart.
b) Lift upwards.
5. Remove the remaining nut, bolt, and washers from the pump half of the coupling guard.
It is not necessary to remove the end plate from the pump side of the bearing housing. You
can access the bearing-housing tap bolts without removing this end plate if maintenance of
internal pump parts is necessary.
6. Remove the pump half of the coupling guard:
a) Slightly spread the bottom apart.
b) Lift upwards.
Item Description
1. Coupling guard
2. Coupling
Check the rotation - Frame Mounted
WARNING:
• Starting the pump in reverse rotation can result in the contact of metal parts, heat
generation, and breach of containment. Ensure correct driver settings prior to starting any
pump.
• Failure to disconnect and lock out driver power may result in serious physical injury or
death. Always disconnect and lock out power to the driver before performing any
installation or maintenance tasks.
• Electrical connections must be made by certified electricians in compliance with all
international, national, state, and local rules.
• Refer to driver/coupling/gear manufacturer's installation and operation manuals (IOM)
for specific instructions and recommendations.
NOTICE:
The coupling used in an ATEX classified environment must be properly certified.
1. Lock out power to the driver.
2. Make sure that the coupling hubs or v-belt sheaves are fastened securely to the shafts.