44
Trial run
Items to check before the trial run
Performing the trial run
■
Prevent other devices around the product from operating.
Other devices incorporated in the system, such as conveyor lines, could create
dangerous situations, since trays may start to flow from upstream when the trial run
is driven.
Check carefully that other elements in the system will not operate when the product
starts running.
■
Make sure to check that wiring, driver card settings, and PLC settings have been
carried out correctly before the trial run.
■
During operation, the transfer speed may not reach the specified value depending on
ambient temperature.
When the carrier wheel cassette has been replaced, perform running operation
thoroughly to eliminate any bends from belts.
When the start-up inspection has finished, perform the trial run with careful attention to
the following points, and check that operation is correctly performed.
Trial run
Check below before the trial run.
・
When the roller transfer MDR and/or idlers have been replaced, check that the
drive belts have been mounted in the correct groove positions.
・
Check all parts are installed.
6.
Control/Operation
F-RAT-NX75 Annex User Manual for IB-P02F-P-FT
Advanced preparation
Product check
Wiring
Maintenance/Inspection
Appendix
IB-P02F-P-FT settings
Control/Operation
Original notice - U1.1
