Isotra HRS-ZIP, Техническое руководство

Страница: 145 / 154

145
SCREEN BLINDS
SCREEN LITE
Assembly
Exterior assembly with sleeve passing through wall
For exterior roller blinds installed with a sleeve passing through a wall and with a crank rod in the interior, it is necessary to
calculate the exact position of the hole for a 30-cm angular rod (15).
- Attach the brackets to a wall or ceiling and install the roller blind in its place. Use a pencil to mark the position of
the box lower corner on the wall or window frame. Remove the roller blind from the brackets and measure the
distance
from the box lower corner to the centre of the hole (A) in the rear part of the box (which serves for inserting the
angular rod to control the transmission system). Mark the same distance on the wall, thus marking the centre of
the hole to be drilled.
- Carefully drill a hole through the wall using an 8-mm drill bit. The hole must be as level as possible.
- Install the roller blind back and insert a sleeve from the interior to check accuracy of the hole position.
Then cut the angular rod to size using a hack-saw. The rod size depends on the wall thickness.
69,5
25
35,5
D
C
B
A
2 1
5
6
6 5 2 3 4
1
D
C
A
B
2- 2
Handle – straight option (K)
Handle with roller blind by delivery connected