Hardware Installations and Upgrades
Intel
®
Server Chassis P4000M Service Guide
35
Installing 8x3.5'' Hotswap Hard Drive Cage Assembly
CAUTION
It is critical that you connect the SAS/SATA data cables correctly from the SAS/SATA backplane to
your server board or RAID controller card. Failure to do so may result in data loss.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
4. Remove the front bezel if it is installed. For instructions, see “Removing the Front Bezel (Pedestal
Only)”.
5. Install the 8x3.5'' Hotswap Hard Drive Cage.
1)
Slide the 8x3.5'' Hotswap Drive Cage into the slot (see letter
A
).
2)
Secure the Hard Drive Cage with the Screw (see letter
B
).
Figure 56. Installing the 8x3.5
''
Hotswap Hard Drive Cage Assembly
6. Make the backplane and server board/RAID controller card cable connections. Refer to the
documentation for your server board and/or RAID controller card for instructions on connecting
backplane cables to your server board or RAID controller card.
1)
Connect an I
2
C cable (letter
A
).
2)
Connect Mini SAS data cables (letter
B
).
3)
Connect power cable (letter
C
).
