IHIMER 9VXE, Оригинальное руководство пользователя

Страница: 89 / 118

MAINTENANCE
9VXE EN 3-20
WB-C310260
Replace the Engine Oil and Engine Oil Filter
1. Stop the engine.
2. Place the container just under the drain port of the
engine.
3. Clean the oil filler cap (2) and around it in order not to
let in foreign matters. Remove the oil filler cap.
4. Remove the drain plug (3) slowly so that oil will not
splash on you. Discharge oil.
5. Check waste oil. If you find a lot of metallic powder,
foreign matters, etc., contact our service office.
6. Turn the filter (4) counterclockwise to detach it using
the filter wrench.
7. Clean dust and foreign matters from the filter
mounting surface.
8. Apply engine oil thinly onto the gasket of a new filter.
9. Turn the filter to the right to mount it. Tighten it
further by approximately 3/4 turn with the filter wrench
after the gasket contacts with the seal surface.
10. Attach the drain plug.
11. Fill the engine with engine oil until the oil level
becomes between the upper limit and lower limit of
the level gauge (1).
12. Idle the engine for several minutes, stop the engine,
and check the level of engine oil 10 to 20 minutes
later. Refill the engine with engine oil up to the
specified level if the oil level is low.
WC-C300320
Upper limit
Lower limit
Oil level gauge