OPERATION
9VXE ENG
2-12
Check after Starting Engine
1. Make sure that all warning lamps are off.
2. Check if the engine exhaust color, sound and
vibrations are proper.
•
Do not accelerate the engine or apply loads to it
quickly when the cooling water temperature is
low.
•
Stop the engine immediately, find the cause and
repair troubles, if some troubles are found.
Warming Up Engine
1. Idle the engine to warm it up for approximately 10
minutes after the engine starts.
2. Lift the bucket from the ground and repeat cycles of
moving the bucket lever to the digging or dumping
position for 10 to 15 seconds and keeping it at the
neutral position for about 10 seconds for five minutes
to raise the hydraulic oil temperature, if the hydraulic oil
temperature is low.
3. Then, repeat all operations, including swinging,
traveling and moving the attachment, three to five
times to warm up all devices.
Do not carry out high-speed operation quickly when
the hydraulic oil temperature is low (below 20ºC).
The proper hydraulic oil temperature is 50ºC to
80ºC. Warm up hydraulic oil up to 20ºC or so and
then carry out operation, if it is necessary to start
operation at low temperature.
WC-C200430
Warming up
WB-C210230
Warung lamps
Содержание 9VXE
