IHIMER 9VXE, Оригинальное руководство пользователя

Страница: 77 / 118

MAINTENANCE
9VXE EN 3-8
Swing Bearing
1. Lower the bucket onto the ground and stop the engine.
2. Supply grease with a grease gun by 3 to 5 strokes through the grease nipple (1) for the
turning bearing of the concentrated piping on the front of the machine.
3. Fill grease every time the upper structure is swung by approximately 90 degrees until it
swings by 360 degrees.
Ring Gear
1. Lower the bucket onto the ground and stop the engine.
2. Fill three to five strokes of grease using a grease gun into the grease nipple (2) on the front
of the machine.
3. Fill grease every time the upper structure is swung by approximately 90 degrees until it
swings by 360 degrees.
WB-C310040
Greasing interval
No. Name Qty
Daily 50h 100h 250h 500h 1000h 2000h
1 Swing bearing 1
2 Ring gear 1
If you carry out greasing while the machine is swinging, you may be caught by it. Do not
swing the machine when greasing.
If greasing is carried out in the same position, grease is not spread all over the swing
bearing. Be sure to swing the machine by approximately 90 degrees and grease the
bearing at different points.
Swing cylinder