IEMCA KID 80 IV Touch, Инструкция по эксплуатации

Страница: 21 / 122

2 - INFORMATION FOR USE KID 80 SIV
EN
2 - Pag. 7 / 71
2.5.1 BAR LOADING CYCLE - FACING PROCEDURE
The following procedure describes the feeding of a new bar until the facing position is reached:
Set to manual mode
then press the key that allows to enter the
quick bar loading function to the facing position.
Press the key for 6 seconds
The bar feeder starts the bar loading cycle, which
stops when the new bar is positioned. The loading
cycle of the new bar takes into account parameter 3
(facing mode) and parameter 2 (facing position).
If the operator releases the key, the cycle goes
on until it is completed.
INFORMATION:
Without the open collet signal from lathe, the bar feeder carries out the above
mentioned procedure, but the bar stops before entering the lathe collet (waiting
for the open collet signal). With the open collet signal from lathe, the bar is
loaded and positioned past the lathe collet according to parameters 2 and 3.
WARNING - CAUTION:
Check that the bar to be loaded in the magazine is present.
Guide channels or Bar feeder Bar
bar pusher Reset loading and
change facing