CS-F620TR Programming Software Manual
(rev 1.0) -
Common Programming Screen
60
Group
Row
Description
Default
Trunking
Parameters
Number of
Preamble Bits
Select “0” through “7”. Selects number of initial bits sent
out with low speed data records to ready the decoder.
Used for both PassPort and LTR systems.
2
Trunking
Parameters
Number of
Hang Bits
Select “0” through “7”. Selects number of bits sent out at
the end of the low speed data record to aid the decoder.
Used for both PassPort and LTR systems.
2
Option
TX Low
Power for all
modes
Select “Enable” or “Disable”. Selecting “Enable” forces
to radio to start in low power. The “RF Pwr” field in the
“Conv.”
programming screen or the
Repeater Setting
programming sub-screen over-rides this. Programming
and activating a
TX Power
key will over-ride this also.
Disable
Option
Odometer
Write
Select “Enable” or “Disable”. Selecting “Enable” allows
certain key radio “accounting” information (such as run
time) to be periodically recorded to the radio’s memory.
To use the run time fields in the
Field Data
programming
screen you must enable this. Enabling this also activates
the Total Radio Runtime field in the
Field Data
programming screen.
Disable
Option
Display
Sequencing
Select “Enable” or “Disable”. Selecting “Enable” forces
the radio on start up to continuously scroll detailed
information about the current PassPort, LTR or
Conventional system you have selected. This can be
over-ridden by toggling the
Mode Display Type
key
(though if power is cycled, the display will revert to
“Scroll”).
Disable
Option
PassPort
CRC LOS
Tone
Select “Enable” or “Disable”. Selecting “Enable” causes
the radio to emit a short tone whenever it goes into search
mode (roam) because CRC is not sufficient.
Disable
Option
PassPort
RSSI LOS
Tone
Select “Enable” or “Disable”. Selecting “Enable” causes
the radio to emit a short tone whenever it goes into search
mode (roam) because RSSI is not sufficient.
Disable
Scrambler
Type
Select “Rolling” or “Non-Rolling”. The optional UT-109
(#02) or UT-110 (#02) voice scramble unit is required for
this functionality (remove the UT-108 DTMF decoder
unit to install). The UT-109 is a “Non-Rolling” type
scrambler so select “Non-Rolling” in this field if
installing a UT-109. The UT-109 will work with
Conventional, LTR or PassPort. The UT-110 is a
“Rolling” type scrambler so select “Rolling” in this field
if installing a UT-110. The UT-110 can be used with
LTR or PassPort, but only if the Synchronous Capture
field is set to “Continuous”. If the Synchronous Capture
field is set to “Standard” the scrambler can only be used
in Conventional mode.
Rolling
Scrambler
Group Code
Select 1 through 4. Selects group code. This setting is for
the UT-110 only as the UT-109 does not utilize group
codes.
1
