CS-F620TR Programming Software Manual
(rev 1.0) -
PassPort Programming Screen
26
Group
Field
Description
Default
Suggested
Settings
Scan
Auto Group
Select
Select “Enable” or “Disable”. Selecting
“Enable” here puts the radio automatically into
group scan as this system is selected. The
groups scanned will be the groups set to “Yes”
in the Scan Member field of the PassPort
Talk
Group Setting
programming sub-screen (see
page 27). Even if this field is enabled, Scan can
be toggled between “Disable” and “Enable” if
the
Scan
key is pressed (assuming “Edit TG
List” is set to “Enabled”). Note: if Block Mode
is “Enabled” then the type of scan used (if this
field is enabled) will be “Block”. Otherwise, it
will be “Individual”.
Disable
(Blank)
Set as
needed.
Scan
Edit TG
List
Select “Enable” or “Disable”. Allows user to
manually edit the groups being scanned. These
edits are normally lost if the user changes
systems or cycles power to the radio (though
not when changing groups) unless the Save TG
Scan field is enabled.
Disable
(Blank)
Set as
needed.
Scan
Save TG
Scan
Select “Enable” or “Disable”. Allows user
changes to the groups being scanned to be
saved when the radio’s power is cycled or the
system is changed.
Disable
(Blank)
Set as
needed.
DTMF
Decode ch
Select “None” or any of the “DTMF Decode
Pri-Codes” listed. If a “DTMF Decode Pri-
Code” has been selected, the radio will emit a
ring tone and flash a “bell” icon if the proper
DTMF sequence of digits is received. You
must set up a DTMF decode entry to use this
function (see the
DTMF Decode
programming
screen - page 48). If the
Select Call
key is
pressed, the radio will also mute to dispatch
traffic until DTMF digits matching the Primary
Code or Secondary Code digit string for the
selected DTMF entry has been received.
None
(Blank)
Set as
needed.
Scrambler
ON/OFF
Select “OFF,” “ON” or “Inhibit”. Setting this
to “OFF” sets the scrambler off as an initial
setting. Setting this to “ON” turns the
scrambler on as an initial setting. The
Scrambler
key can then be used to toggle this
function on and off. Setting this field to “Inh”
(Inhibit) will prevent the scrambler from being
used while this system is selected. See the
Scrambler Type field in the
Common
programming screen (page 60) for more
information on setting up the scrambler.
OFF
(Blank)
Set as
needed.
Scrambler
Code
Set from 1 to 255. With the UT-109 (“Non-
Rolling” type) only the value 1 through 32 will
work. With the UT-110 (“Rolling” type) values
from 1 to 255 will work.
1
Set the code
number to
match the
code used by
the customer
in general.