IBM xSeries 300, Руководство по обслуживанию

Страница: 51 / 160

Installing and Connecting the Hayes Modem
Notes
1. If you are not familiar with the Hayes modem, refer to the Hayes user’s
guide.
2. Power and frequency requirements:
v
Input voltage: 230 V +/-10%, 50 Hz (ac)
v
Nominal output voltage: 9 V ac
v
Maximum output voltage: 12.1 V ac
v
Rated load current: 800 mA ac 50 Hz
1. Unpack and install the modem on the rear side of the NAS.
2. See Figure 1-43 on page 1-38 and connect the cables as follows:
Note: Cables
«1¬
and
«2¬
are country-dependent.
a. ____ Connect the power cable
«1¬
from connector “9.0V-AC” to a
standard 3-pin grounded ac outlet.
b. ____ Connect the interface cable
«3¬
from the “DTE INTERFACE”
modem’s connector to the NAS’s connector
«4¬
.
c. ____ Connect the switched network telecommunication cable
«2¬
from the line connector to the telecommunication line.
Figure 1-41. Hayes Modem Front View
Figure 1-42. Hayes Modem Rear View
Installing the NAS and Its Modem
Chapter 1. Installing and Configuring the NAS and Its Modem
1-37