IBM x3100 M5 Type 5457, Инструкция по установке и обслуживанию

Страница: 233 / 688

Replacing a simple-swap hard disk drive:
This procedure applies only to 4U server models with non-hot-swap power
supplies.
The 4U server model with non-hot-swap power supplies supports up to four
3.5-inch simple-swap SATA hard disk drives, which are accessible from the front of
the server.
Note: Only 3TB or below hard disk drive options are supported by the 4U server
model with non-hot-swap power supplies .
You must disconnect all power from the server before you remove or install
simple-swap drives. Before you install a simple-swap SATA hard disk drive, read
the following information:
Install the drives starting from the top bay to the bottom bay (bay 3, 4, 5, and then
6). The following tables list the IDs of the hard disk drives:
Table 34. IDs of simple-swap drives
Drive bay HDD ID
3 0
4 1
5 2
6 3
v The simple-swap SATA hard disk drives connect to the SATA 0 through SATA 3
connectors on the system board as follows:
– System board end cable connector 0 connects to the SATA 0 connector on the
system board.
– System board end cable connector 1 connects to the SATA 1 connector on the
system board.
– System board end cable connector 2 connects to the SATA 2 connector on the
system board.
– System board end cable connector 3 connects to the SATA 3 connector on the
system board.
v
– Hard disk drive 0 connects to the SATA 0 connector on the system board.
– Hard disk drive 1 connects to the SATA 1 connector on the system board.
– Hard disk drive 2 connects to the SATA 2 connector on the system board.
– Hard disk drive 3 connects to the SATA 3 connector on the system board.
Note: Under RAID mode:
1. In uEFI setup menu:
v
Drive 0 indicates hard disk drive 0.
v
Drive 1 indicates hard disk drive 1.
v
Drive 2 indicates hard disk drive 2.
v Drive 3 indicates hard disk drive 3.
2. In MegaRAID Storage Manager utility:
v Slot 0 indicates hard disk drive 0.
Chapter 6. Removing and replacing components
217