IBM x3100 M5 Type 5457, Инструкция по установке и обслуживанию

Страница: 306 / 688

Removing the operating temperature enhancement kit
Use this information to remove the operating temperature enhancement kit
To remove the operating temperature enhancement kit on the 4U server model
with non-hot-swap power supplies, complete the following steps. For 5U server
models with hot-swap power supplies, please see the next sub-section.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Remove the bezel (see “Removing the bezel” on page 40).
4.
Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
5.
Remove the side cover (see “Removing the side cover” on page 38).
6. Disconnect the thermal sensor connector from the system board and open the
cable clips.
7.
Remove the thermal sensor board by pulling apart the securing clips of the
thermal sensor board holder.
Thermal sensor
connector
Figure 203. Thermal sensor connector removal from system board for 4U server model with
non-hot-swap power supplies
290
System x3100 M5 Type 5457: Installation and Service Guide