IBM x3100 M5 Type 5457, Инструкция по установке и обслуживанию

Страница: 104 / 688

5. Secure the side cover in place with the two chassis screws on the rear of the
side cover.
For the 5U server model with hot-swap power supplies, complete the following
steps in order to remove the side cover. For 4U server models with non-hot-swap
power supplies, please see the above sub-section.
Attention: The cover lock must be in the unlocked (opened) position before you
install the side cover.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
3.
If you removed the upper and lower bezels, reinstall them before you replace
the side cover (see “Replacing the lower bezel” on page 190 and “Replacing the
upper bezel” on page 192).
4. Position the lip at the bottom edge of the side cover on the ledge at the bottom
of the chassis; then, rotate the cover up to the chassis. Press down on the cover
release latch and push the cover into the chassis until it latches securely into
place.
Figure 64. Side cover installation for 4U server model with non-hot-swap power supplies
88
System x3100 M5 Type 5457: Installation and Service Guide