IBM x3100 M5 Type 5457, Инструкция по установке и обслуживанию

Страница: 322 / 688

8. Reconnect any cables that you disconnected during the removal of the old
microprocessor.
9.
Secure the SATA signal cables with the retention-clips.
10. Install the air baffle (see “Replacing the air baffle” on page 185).
11.
Install the side cover (see “Replacing the side cover” on page 182).
12. Stand the server back up in its vertical position.
13. Install the bezel (see “Replacing the bezel” on page 188).
14. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
To install the microprocessor and heat sink on the 5U server model with hot-swap
power supplies, complete the following steps. For 4U server models with
non-hot-swap power supplies, please see the above sub-section.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2.
Touch the static-protective package that contains the microprocessor to any
unpainted metal surface on the server. Then, remove the microprocessor from
the package.
3. Remove the protective cover, tape, or label from the surface of the
microprocessor socket, if any is present.
4. Rotate the release lever on the microprocessor socket to the fully open
position.
Attention: Make sure that the release lever on the microprocessor socket is
in the fully open position before you insert the microprocessor in the socket.
Failure to do so might result in permanent damage to the microprocessor,
microprocessor socket, and system board.
5. Carefully grasp the microprocessor and place the microprocessor into the
microprocessor socket.
Note: To maintain correct orientation between the microprocessor and the
microprocessor socket during installation, observe the following information:
Heat sink
System board
Figure 224. Heat sink installation for 4U server model with non-hot-swap power supplies
306
System x3100 M5 Type 5457: Installation and Service Guide