IBM x3100 M5 Type 5457, Инструкция по установке и обслуживанию

Страница: 69 / 688

11. Carefully turn the server on its side so that it is lying flat.
Attention:
Do not allow the server to fall over.
12. Connect the power (power connector P9) and signal cables to the drive.
Note: Route the signal cable so that it does not block the airflow to the rear of
the drives or over the microprocessor and dual inline memory modules
(DIMMs).
If you have other devices to install, do so now. Otherwise, go to “Completing the
installation” on page 82.
To install a DVD drive on the 5U server model with hot-swap power supplies,
complete the following steps. For 4U server models with non-hot-swap power
supplies, please see the above sub-section.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2.
Follow the instructions that come with the drive to set jumpers or switches, if
there are any.
Note: You might find it easier to install the new drive from the front and then
attach the cables.
3. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
4. Unlock and remove the side cover (see “Removing the side cover” on page
38).
5.
Remove the lower bezel (see “Removing the lower bezel” on page 42).
6. Remove the upper bezel (see “Removing the upper bezel” on page 43).
7.
Touch the static-protective package that contains the new DVD drive to any
unpainted metal surface on the server; then, remove the DVD drive from the
package and place it on a static-protective surface.
Drive retainer
clip
Figure 31. DVD drive installation for 4U server models with non-hot-swap power supplies
Chapter 2. Installing optional devices
53