IBM x3100 M5 Type 5457, Инструкция по установке и обслуживанию

Страница: 93 / 688

3. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
4. Remove the side cover (see “Removing the side cover” on page 38).
5. Remove the air baffle (see “Removing the air baffle” on page 39).
6. Follow any special handling and installation instructions that come with the
thermal solution fan kit.
7. Insert the thermal solution fan kit:
a. Grasp the system fan by the blue point and lower it into the server, making
sure it latches on to the chassis.
b. Connect the fan cable to the system board (see “System-board internal
connectors” on page 30).
8. If you have other devices to install, do so now. Otherwise, go to “Completing
the installation” on page 82.
To install the thermal solution fan kit on 5U server models with hot-swap power
supplies, complete the following steps. For the 4U server model with non-hot-swap
power supplies, please see the above sub-section.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2.
Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page 38).
4. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
5. Insert the thermal solution fan kit:
Second fan
power connector
1
2
3
Thermal solution
fan kit
Figure 52. Thermal solution fan kit installation for 4U server model with non-hot-swap power
supplies
Chapter 2. Installing optional devices
77