IBM x3100 M5 Type 5457, Инструкция по установке и обслуживанию

Страница: 417 / 688

Firmware Error : Sys Boot Status :
806f000f-220102ff Subsystem [MemoryElementName] has insufficient memory for operation. (ABR Status)
Explanation: This message is for the use case when an implementation has detected that the usable Memory is
insufficient for operation.
May also be shown as 806f000f220102ff or 0x806f000f220102ff
Severity: Error
Alert Category: Critical - Memory
Serviceable:
Yes
CIM Information: Prefix: PLAT and ID: 0132
SNMP Trap ID: 41
Automatically notify Support: No
User response:
1. Make sure the server meets the minimum configuration to start (see Power-supply LEDs).
2. Update the server firmware on the primary page. Important: Some cluster solutions require specific code levels
or coordinated code updates. If the device is part of a cluster solution, verify that the latest level of code is
supported for the cluster solution before you update the code.
3. (Trained technician only) Replace the system board.
Firmware Error : Sys Boot Status :
806f000f-220103ff The System [ComputerSystemElementName] encountered firmware error - unrecoverable boot
device failure. (ABR Status)
Explanation: This message is for the use case when an implementation has detected that System Firmware Error
Unrecoverable boot device failure has occurred.
May also be shown as 806f000f220103ff or 0x806f000f220103ff
Severity: Error
Alert Category: Critical - Hard Disk drive
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0770
SNMP Trap ID:
5
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI(POST) error code for this event can be found in the logged
IMM message text. Please refer to the UEFI(POST) error code in the "UEFI(POST) error code" section of the
Information Center for the appropriate user response. Firmware Error : Sys Boot Status :
806f000f-220102ff • 806f000f-220103ff
Appendix A. Integrated management module II (IMM2) error messages
401