IBM SAN768B, Инструкция по установке, обслуживанию и эксплуатации, Страница: 67 / 208

Follow these steps to configure the IP addresses for both CP blades (from the
active CP blade):
1.
Log in to the active CP as
admin
using the serial connection.
2. Set up the SAN768B IP address by entering the ipaddrset -chassis command at
the prompt.
swDir:admin> ipaddrset -chassis
Enter the information at the prompts. Specify the -chassis IP address. The -sw 0
IP address is no longer valid on this chassis.
Note:
The addresses 10.0.0.0 through 10.0.0.255 are reserved and used
internally by the SAN768B. External IPs must not use these addresses.
3. Set up the CP0 blade IP address by entering the ipaddrset -cp 0 command at
the prompt.
swDir:admin> ipAddrSet -cp 0
Enter the requested information at the prompts.
4. Set up the CP1 blade IP address by entering the ipaddrset -cp 1 command at
the prompt.
swDir:admin> ipAddrSet -cp 1
Enter the requested information at the prompts.
The following is a sample IP configuration for the SAN768B (chassis) and the
two CP blades (cp0 and cp1).
swDir:admin> ipaddrset -chassis
Ethernet IP Address [0.0.0.0]: 123.123.123.120
Ethernet Subnetmask [0.0.0.0]: 123.123.123.123
Fibre Channel IP Address [0.0.0.0]:
Fibre Channel Subnetmask [0.0.0.0]:
Issuing gratuitous ARP...Done.
Committing configuration...Done.
swDir:admin> ipaddrset -cp 0
Host Name [cp0]:
Ethernet IP Address [10.77.77.75]:
123.123.123.121
Ethernet Subnetmask [0.0.0.0]: 123.123.123.123
Gateway IP Address [0.0.0.0]: 123.123.123.124
IP address is being changed...Done.
Committing configuration...Done.
swDir:admin> ipaddrset -cp 1
Host Name [cp1]:
Ethernet IP Address [10.77.77.74]:
123.123.123.122
Ethernet Subnetmask [0.0.0.0]: 123.123.123.123
Gateway IP Address [0.0.0.0]: 123.123.123.124
IP address of remote CP is being changed...Done.
Committing configuration...Done.
swDir:admin>
reboot
5. Enter reboot at the prompt to reboot the SAN768B
Chapter 3. Starting and configuring the SAN768B
35