IBM SAN768B, Инструкция по установке, обслуживанию и эксплуатации, Страница: 64 / 208

The initial physical hardware installation continues with the following steps:
v
“Providing power to the SAN768B” on page 33
v “Establishing a serial connection and logging on to the SAN768B” on page 33
v
“Configuring the IP addresses” on page 34
The following additional steps are customer responsibilities, generally completed
during the initial configuration:
1. Establish an Ethernet connection. See “Connecting an Ethernet cable and
opening a Telnet session” on page 36.
2. Specify a switch name. See “Customize a switch name” on page 36.
3. Specify a domain ID for the SAN768B. See “Setting the Domain ID” on page
37.
4. Verify the PID mode and connect the SAN768B to the fabric. See “Verifying the
PID mode and connecting to the fabric” on page 39.
5.
Enable software licenses. See “Enabling software licenses” on page 39.
6. Configure the optional FS8-18 encryption blade. See “Configuring for
encryption (optional)” on page 42
7. Back up the configuration. See “Verifying correct operation and backing up the
configuration” on page 43.
Configuration Tasks
Connect Serial Cable
between Switch and Host
Log In to Serial Console Port
Set IP Address
Log off Serial Console Port
and Disconnect Serial Cable
Connect Ethernet Cable
and Open Telnet Session
Set Domain ID
Set Date and Time
Install SFPs and
Attach Cables
Manage Cables
Verify Operation and
Back Up Configuration
384b004
Figure 13. Flow of basic configuration tasks
32
SAN768B Installation, Service, and User Guide
|
|