IBM SAN768B, Инструкция по установке, обслуживанию и эксплуатации, Страница: 119 / 208

3. If you are performing a new installation of a router blade, you must either
remove the filler panel or a port blade from the slot where you will install the
router blade.
4.
Orient the router blade so that the ports are at the front of the chassis and the
router blade power switch is at the top.
5. Make sure the ejector latches (
2
and
12
) on the router blade are
unscrewed and open.
6. Slide the router blade into the open slot until it is fully seated.
7. Close the latches and tighten the screws (
3
) on the latches.
8. Power on the blade using the power switch at the top of the blade (
9
in
Figure 35 on page 85). Keep the blade in an offline (disabled) state until the
ports are configured.
Note: The router blade will begin POST as soon as the power is turned on.
After POST is complete the firmware version on the blade will
autolevel with the firmware version on the active CP.
9. Verify that the blade power
5
and blade status
6
LEDs are green after the
blade has completed booting up.
10. Verify the installation (see the appropriate section of Chapter 4, “Monitoring
system components,” on page 47). For information about how to check the
status of hardware components using the CLI, see the
Fabric OS
Administrator's Guide , or the Fabric OS Command Reference Manual , which are
located on the product documentation CD.
11. Log into the SAN768B as the admin user.
Configuring FCIP and Fibre Channel routing services and
enabling the ports
Refer to the Fabric OS Administrator's Guide or the Web Tools Administrator's Guide
for detailed information on configuring the router blade. The following steps
provide only a brief overview of the procedure.
1. Verify that the FR4-18i router blade is in an offline (disabled) state until the
ports are configured.
Attention: The ports on the FR4-18i router blade are initially set to
persistently disabled. They will flash amber until they are enabled. This is
normal. If you want to use the FC ports and EX_Ports, you must configure the
Fibre Channel Routing Services feature prior to enabling the ports.
2. Use the portCfgPersistentEnable command to enable standard E_ports or
F_ports.
Note: The GbE ports can only be used once you have configured FCIP and
enabled VE_Ports. See the
Fabric OS Administrator's Guide for detailed
instructions on configuring the Fibre Channel Router ports and GbE
ports on the FR4-18i router blade.
Cabling the FR4-18i router blade
Complete the router blade configuration by installing the SFP transceivers in the
Fibre Channel and GbE ports.
1. Install the SFP transceivers in the Fibre Channel and GbE ports, as required.
Refer to “Removing and installing transceivers” on page 96 for more detailed
instructions.
2. Remove the rubber plugs from the ports to be used.
Chapter 5. Removing and installing components
87