IAI X-SEL PX, Руководство по эксплуатации, Страница: 332 / 560

305
Part 4 Commands

ACHZ (Declare arch-motion Z-axis)
Command, declaration
Extension condition
(LD, A, O, AB, OB)
Input condition
(I/O, flag)
Command,
declaration
Operand 1 Operand 2
Output
(Output, flag)
Optional Optional ACHZ Axis
number
Prohibited CP
Specify the axis number representing the arch-motion Z direction.
The axis number specified in operand 1 will be set as the axis number representing the arch-motion Z
direction.
If the output field is specified, the output will turn ON after this command is executed.
(Note 1) A SCARA axis other than the Z-axis on the load coordinate system (axis No. 3) cannot be
specified as the arch-motion Z-axis.
[Example] ACHZ 3
306
Part 4 Commands

ATRG (Set arch triggers)
Command, declaration
Extension condition
(LD, A, O, AB, OB)
Input condition
(I/O, flag)
Command,
declaration
Operand 1 Operand 2
Output
(Output, flag)
Optional Optional ATRG Position
number
Position
number
CP
Set the arch triggers used for arch motion.
(This setting becomes valid when an ARCH command is executed.)
Set the arch-motion Z-axis position data in the point data specified in operand 1 as the start-point arch
trigger, and set the arch-motion Z-axis position data in the point data specified in operand 2 as the end-
point arch trigger.
ATRG 13 11
(Refer to “Palletizing Setting” – “Arch triggers” under “How to Use.”)
For an arch-motion operation, set it so that a horizontal movement will begin when the start-point arch
trigger is reached during ascent from the start point, and that the end-point arch trigger will be reached
after a horizontal movement is completed during descent.
If the output field is specified, the output will turn ON after this command is executed.
Start-point arch trigger
Position No. 13
End-point arch trigger
Position No. 11
Start point End point
308