90
Decontamination / Repair
The user is responsible for making sure that there are no hazardous materials either in
or on the unit. The level of decontamination should be appropriate to the amount and
type of contaminants on the unit. The user should refer to the appropriate MSDS
information for advice.
The decontamination should be done
BEFORE
outside personnel come into contact with
the machine, and
BEFORE
the unit is sent out for repair or testing. The unit should be
clearly labelled that it has been decontaminated before it is sent.
We have prepared a document to simplify this process. This is available in the appendix,
and at our website
www.huber-online.com.
Cleaning the surfaces
A normal steel cleaning spray is suitable for cleaning the stainless steel surfaces.
Painted areas should be carefully cleaned with a gentle detergent.
Checking the pump seal
As rotating pump seals are never absolutely tight, operation with a thermal fluid that
does not easily evaporate will cause drips to build up on the seal.
These drips are collected and may be checked and drained off via the drain drip tray (7)
using its drain connection.
Plug contacts
Each socket has a protective cap belonging to it. If a connector is not required, then it
should be covered with this cap.
