3.
In the
System
section, select the
Maintenance mode
panel.
4.
On the
Maintenance mode
screen, set the
Maintenance mode
switch to the
On
position (
),
and then click
OK
.
Rack information
The storage enclosures can be installed into most standard server racks.
For detailed safety information, see the rack documentation and the safety guide at
support/Safety-Compliance-EnterpriseProducts
.
Rack warnings
For detailed safety information, refer to the rack documentation and the
Safety Guide
provided with the
rack product.
WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
• The leveling jacks are extended to the floor.
• The full weight of the rack rests on the leveling jacks.
• The stabilizing feet are attached to the rack of a single-rack installation.
• Only one component is extended at a time. A rack may become unstable if more than one
component is extended for any reason.
CAUTION:
Use extreme caution when installing and pulling units from the rack. They can slip and
fall, damaging the StoreOnce System or causing personal injury.
HPE is not responsible for any injury or damage caused by the mishandling of the StoreOnce
System. Always use at least two people to lift and install an enclosure into the rack.
Installing and connecting the capacity upgrade enclosures
Where to install the enclosure
Install the first capacity upgrade enclosure below the server node.
Install a second capacity upgrade enclosure below the first capacity upgrade enclosure.
76
Installing capacity upgrade kits
