HP rp7400, Руководство по оборудованию

Страница: 127 / 162

rp7400 Server Boot up
127
An example of an added users information would be:
. User’s Name: Joe Smith
. Organization’s Name: IT Support
. Dial-back configuration: Disabled
. Access Level: Operator
. Mode: multiple
. User’s state: enabled
For the number 1 user, the Access level is administrator. The Mode entry of single only allows entry for
that user one time, then access will be denied. A Mode entry of multiple allows unlimited entries into the
GSP.
Removing Users
You can remove (disable) a GSP user with the same Security options and access control (SO) command used to
add a user.
To remove a user, perform the following steps:
1. Go into the GSP with the ctrl+b entry.
2. At the GSP prompt, enter the Security options and access control (SO) command:
GSP> so
3. The first prompt you will see with the so command is for GSP wide parameters:
GSP wide parameters are:
. Login Timeout: 1 minutes.
. Number of password Faults allowed: 3
. Flow Control Timeout: 5 minutes.
Do you want to modify the GSP wide parameters? (Y / [N]) __
At this point you can modify the GSP wide parameters, or continue with removing a user. To remove
users, respond N for no.
NOTE
You will have to step through each user number until you reach the user to be removed.
4. When you access the number of the user to be removed, you must change the data in the prompts for that
number.
It is important that, at a minimum, you need to modify the User’s state to Disabled.