Hog Technologies Stripe Hog SH5000, Руководство по эксплуатации

Страница: 66 / 122

66
General Maintenance
• Inspect and lubricate ball valves periodically.
Make sure to open and close all ball valves at
least once each month to keep them free and
operating properly.
• Inspect and lubricate the manual bypass valve
to keep it operating properly.
Charge Pump
Information and owner’s manuals for the charge
water system components are included with this
manual. Refer to this information for additional
operation and service data.
• Periodically inspect the charge pump, hoses
and fittings for leaks and signs of wear or
deterioration. Any questionable or leaking
components should be repaired or replaced
before operating the system.
• If the Charge Pump pressure is lower than 30
PSI (2 Bar), replace both of the filters between
the charge pump and the high pressure pump.
• To change the filters, make sure the system is
not engaged and the switches for the charge
water pump and PTO’s are off. If necessary,
relieve the pressure in the system. Refer to
the filter installation and maintenance guide
included with this manual for detailed informa-
tion on replacing the filter elements.
Be sure to activate the charge pump and flush
the low pressure side of the UHP pump and
charge water system using the flush valve
before operating the UHP pump after chang-
ing the filters.
Charge Pump
UHP Pump Oil Sump Level Indicator and Oil Fill
Typical UHP Pump Crankcase Drain Valve and Safety Plug
Safety Plug
Drain Valve
Charge Water Filters and Flush Valve
Level Indicator
Flush
Valve
One Micron
Filter
Charge Water
Filter