Hog Technologies Stripe Hog SH5000, Руководство по эксплуатации

Страница: 101 / 122

101
Troubleshooting Guide
Noises and Vibrations:
• Loose blower belts or pump belts - adjust or replace belts
• Blower or drive belts out of alignment - align and adjust belts
• Hog Head rotation extremely high - turn head rotation dial counterclockwise to reduce head speed
Hog Arm won’t raise:
• Float mode activated - disengage float function
• Hydraulics not engaged - engage PTO to activate hydraulic system
• Hydraulic fluid low - add fluid to the hydraulic fluid reservoir
• Hose or fitting broken or leaking - tighten loose fitting or replace broken hose or fitting
Head doesn’t spin or spins slowly
• Hydraulics not engaged - make sure PTO is engaged to activate hydraulic system
• Debris packed around thru-shaft or spray bar - clean thru-shaft or spray bar
• Hog Head shroud is concave and not convex - repair or replace shroud
• Flow control is shut off - turn on flow ball valve
• Electric connection is unplugged or no voltage to coil - check that LED light on coil is lit and repair
circuit or replace coil as necessary
Appendix B:
HOG HEAD
WATER LEAKS
Hose fitting indicator port leaking:
• Fitting Loose - tighten fitting or replace hose and fitting
Fluid end manifold leaking at rectangular hole in manifold block:
• Stuffing box seal is worn out - replace stiffing box ring seal
Fluid end manifold leaking at round hole on top of manifold block:
• Valve seals worn - replace valve seal or valve
Weep holes dripping at high pressure hose connection on thru-shaft motor:
• Loose swivel nut - hand tighten swivel nut
• Leaking swivel seal - remove spent seal, check shaft nipple, clean thoroughly and replace with
new seal
• Cracked swivel or thru-shaft - remove shaft assembly and disassemble to inspect shaft and replace
if damaged or cracked on nipple end
Problem Problem