Hog Technologies Stripe Hog SH5000, Руководство по эксплуатации

Страница: 42 / 122

42 42
Stripe Hog Systems
Good Nozzles
Bad Nozzle
the high pressure system and set the operating
pressure to a safe level. Make sure the head ro-
tation speed dial is set to 0 so the spray bar does
not rotate. Staying well clear of the water jets,
visually inspect the spray pattern of each nozzle.
If the spray is tight with a cohesive stream for 1/2
- 1 1/2 inches from the nozzle, it is good.
Remove Nozzle from Service if:
A) Nozzle is split or damaged;
B) Nozzle is clogged;
C) Nozzle water spray is fanned out;
D) Nozzle’s ability to hold pressure is suspect;
E) Nozzle’s hex head is worn excessively from
blasting.
F) Nozzle threads are damaged.
Refer to the Stripe Hog Training video available on
DVD or at www.stripehogsupport.com for instruc-
tions on changing nozzles.
DANGER
THE HIGH PRESSURE STREAM FROM THE SPRAY NOZZLES
CAN CAUSE SEVERE INJURY OR DEATH IF IT COMES
IN CONTACT WITH HANDS, FEET OR ANY PART OF A
PERSON’S BODY. IT CAN ALSO PROJECT LOOSE DEBRIS
IN THE AREA OF THE HOG HEAD WITH ENOUGH FORCE TO
CAUSE SERIOUS INJURY, PARTICULARLY TO THE EYES.
HIGH PRESSURE WATER CAN TEAR OFF SKIN AND INJECT
WATER DIRECTLY INTO THE BLOOD STREAM WHICH CAN
BE FATAL. ALWAYS DEACTIVATE THE HIGH PRESSURE
SYSTEM BEFORE RAISING THE HOG HEAD AND MAKE SURE
THE AREA IS CLEAR OF PEOPLE, HANDS AND FEET BEFORE
ENGAGING THE PTO AND DUMP VALVE SWITCH FOR THE
HIGH PRESSURE SYSTEM TO CHECK THE NOZZLES WITH
THE HOG HEAD RAISED.
When replacing nozzles make sure to check the
flow and pressure rating and use only nozzles with
a manufacturer’s pressure rating of at least the
pump’s operating pressure or a burst rating of no
less than 54,000 PSI (3,723 Bar.) We recommend
that you only use nozzles, high pressure hoses and
fittings supplied by Hog Technologies to ensure the
nozzles and other components are compatible with
your Ultra High Pressure Waterblasting System.
Prior to installation, make sure the nozzles have
no clogged orifices. Also, check to ensure nozzles
are sharp and not worn. To prevent galling, make
sure to apply anti-seize to the threads before in-
stalling the replacement nozzle and be careful not
to get anti-sieze on seating area of the nozzles.
Note:
To increase the life of the spray bars and
nozzles, always remember to install the
spray bar shield after testing the nozzles and
before beginning blasting operations.