Hog Technologies Stripe Hog SH5000, Руководство по эксплуатации

Страница: 107 / 122

107
Appendix D:
1. Inspect all hoses for chaffing and signs of wear.
2. Check fuel levels and make sure you have enough for the shift.
3.
Check engine and all systems fluid levels. Refer to the truck and OMSI Drive
operating manuals.
4. Check all waterblasting and vacuum components for oil leaks, damaged or loose
bolts and parts.
5. Inspect the Hog Head for loose components and damage.
6.
Check vacuum canister for water and the vacuum filter. Drain water or clean filter
as required.
7. Check the vacuum blower and UHP pump drive belt tension and alignment.
8.
Check clean water tank level and fill if necessary.
9. Drain debris tank water and check debris level. Empty if necessary.
10. Walk around truck and visually check all components and look for obvious prob-
lems.
Note:
If you operate at freezing temperatures or even temperatures below 60 degrees Fahrenheit
(16
0
Celsius), it will be necessary to operate the system, including engaging the blower and
high pressure pump, at IDLE speed only under load, until oil heats up above 60 degrees
Fahrenheit (16
0
Celsius).
Pre-Start Inspection Pre-Start Inspection
Checklists