Hofmann Megaplan Service Manual megaline SSENCE
SSENCE 400/600
Page 6 of 52
2.1.2 Exchange of targets - electronically data (all models)
With each new target (spare part or basic delivery) a file with basic calibration data is delivered
from the factory. (see also 2.1.3) If you replace the target the new file must be saved assigned
to the position on the car.
Each Target has a unique position on the car.
There are four files assigned to the targets in this position:
Target_Data_0.yml = Target front left
Target_Data_1.yml = Target front right
Target_Data_2.yml = Target rear left
Target_Data_3.yml = Target rear right
This files must be in folder D:/SSENCE.
The data are ready to use, just rename the target file to the target name on the car's place.
(see table)
Save the files assigning to the position on the car. It is not necessary to make a
calibration, because targets are calibrated in the factory with standard clamps.
2.1.3 Loose of the target files:
Please send target ID number to Hofmann Megaplan GmbH.
Target ID Number.
Distance value (necessary in the factory- part of the target calibration
file)
We send you the associated file.
If there is a suspicion that the clamps are deformed, please perform a target
calibration. (no camera calibration required)
