2. Install the secondary riser cage
on page 34.
4. Install the server into the chassis
5.
Connect all peripheral cables to the server.
on page 23.
Remove the primary riser cage
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
either riser blank or the riser cage is installed.
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
on page 23.
2.
Disconnect all peripheral cables from the server.
3. Remove the server from the chassis
on page 28.
5. Remove the secondary riser cage
on page 33.
6.
If an expansion board with internal cabling is installed on the riser cage, disconnect these internal
cables from the expansion board.
7.
Remove the primary riser cage.
36
Operations
