Hayward OmniPL HLXPROUPG, Руководство по установке, Страница: 8 / 32

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
6
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Controller
The Controller comes with a 15 ft cord and plugs into the OmniPL mainboard. It should be mounted in a location that is convenient for the user to view and
change pool/spa settings and within range of the home’s wireless network access point. When considering the mounting location, make sure there is enough
clearance above the enclosure so that the flip door will be able to be opened fully. Also be sure to allow enough clearance below the Controller to access the
USB and Ethernet connectors. For best viewing results, position the Controller where it won’t be subjected to direct sunlight.
The Controller has two keyhole cutouts on the back of its enclosure. A mounting template is provided on page 26. To mount, screw two appropriate fasteners into
the mounting surface at the desired location as shown below. Tighten until the bottom of the screw heads are 1/8” off the mounting surface. Position the Con-
troller cutouts over the screw and slide the unit downward. You may have to tighten or loosen the screws slightly to fully engage the screw heads to get a snug fit.
Run the Controller’s 15 ft cable back to the OmniPL mainboard and plug it into the connector shown on page 5. There are rubber plugs covering the USB port
and Ethernet port on the bottom of the Controller for protection from the elements.
The Ethernet port is available if a wired connection to the access point is desired over the built-in wifi. For Ethernet connections, use outdoor rated Cat5e or Cat6
Ethernet cable. Connect one end to the Controller and the other to an available LAN port (not WAN) on the home router or access point as shown.
Ethernet port
Router
LAN port
2.85”