Hayward OmniPL HLXPROUPG, Руководство по установке, Страница: 27 / 32

25
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
options are as follows:
Name - Rename the accessory to whatever name is desired.
Relay - Select the relay that the accessory is wired to.
Delete an Accessory -
From this screen, if you wish to delete an accessory that is currently configured, select the trash can on the right of the
name of the accessory that you wish to delete.
NOTE: The system does not allow you to configure a pump or a valve to accessory equipment in the Backyard.
If Sensors is selected:
Add Sensor -
Pressing “Add Sensor” from this screen will take you through the full configuration for adding a new sensor. These steps are described in
the Configuration Wizard portion of this manual.
Select a Sensor -
Once you select a sensor, all of the options for that sensor will appear on the next screen. These options are as follows:
Name - Rename the sensor to whatever name is desired.
Location - Select the location that the sensor is wired to.
Delete a sensor -
From this screen, if you wish to delete a sensor that is currently configured, select the trash can on the right of the name of the sensor
that you wish to delete.
If Interlocks is selected:
Add Interlock -
Pressing “Add Interlock” from this screen will take you through the full configuration for adding a new interlock. These steps are described
in the Configuration Wizard portion of this manual.
Select an Interlock -
Selecting an interlock from this screen will allow you to view that interlock’s configuration. However, you cannot edit a pre-existing
interlock. In order to change an interlock’s configuration, you have to delete the obsolete interlock and create a new one.
Delete an Interlock -
From this screen, if you wish to delete an interlock that is currently configured, select the trash can on the right of the name of the
interlock that you wish to delete.
NOTE: If there are currently no interlocks configured on your system, then the button will appear as “Add Interlock” instead of “Interlocks”. In this case,
pressing “Add Interlock” will take you through the full configuration for adding a new interlock. These steps are described in the Configuration Wizard por-
tion of this manual. Once an interlock has been created, the button will say “Interlocks”.
If System Options is selected:
Modify Network Setup -
Press this button to modify or setup a wired or wireless connection.
Would you like to set up a network Connection now? Select the type of connection you would like to setup/modify or select “Not Now”.
Wired - A wired connection, requires an Ethernet cable from the OmniPL to the router. After selecting “Wired”, the system will display the ip ad-
dress and other network properties. Press the check mark and the OmniPL will verify the network connection. You can now exit back to the main
menu and continue with the Configuration Wizard.
Wireless
- Make this selection when setting up a wireless connection. Once the system is done running through the diagnostics, press the check
mark to continue to the next section of the Configuration Wizard.
Switch Network - This selection allows you to look at a list of available networks and change from the current connection.
Change Password - This selection will allow you to enter a new wifi password. Use this option if you’ve changed the wifi password on your
router/access point.
Network Properties - Network properties will allow you to set a static ip address for the OmniPL. The OmniPL will default to a dynamic ip
connection and display current network information such as the local/gateway ip addresses. If a static connection is desired, select “Static”
and enter the required network information.
Diagnostic - This selection will re-establish a connection to your wireless network and display current network information such as wifi SSID,
signal strength, and the local/gateway ip addresses.
Not Now - Skip network setup and continue with Configuration Wizard.