______________________________________________
HARRIS
888-9058-001
WARNING: Disconnect and lockout AC primary power prior to servicing
70
Figure 3-2 CD-1A Exciter, S3 Location
3.11 eCDi™ Configuration
Now that the eCDi™ unit is turned on, connect an external computer with a 10 base T
network connection directly to the ethernet port on the front of the eCDi™ using the
provided ethernet cable labeled “Configure.” This port
must
be used for the initial
configuration of the unit.
As of eCDi™ software Rev 2.6.K, the configuration port has a
fixed IP address of
192.168.217.254
or a name of ecdi-local on all units
.
STEP 1:
The eCDi™ supports DHCP which means the computer to be connected
for configuration can be set to “Obtain an IP Address Automatically” as
shown in Figure 3-3. In this mode eCDi™ will assign the remote
computer an IP address when it connects.
•
Right-click on Network Neighborhood and select Properties. This can
also be accessed by selecting “Network and Dialup Connections” in
the Control Panel.
•
Next, right-click on the LAN connection and select Properties again.
•
Click on Internet Protocol (TCP\IP) and click on Properties again.
•
This brings up the IP address screen. Select “Obtain an IP address
automatically” as shown. Click OK and close all windows and re-boot.
