Hardy Process Solutions HI 6500 Series, Руководство пользователя

Страница: 59 / 202

Network Configuration
49
•
•
•
•
•
•
•
6: WEIGHT SAMPLE CMD:
Write a #6 to the command register to run the Weigh
Sample command to set up the calibration of the Counts (if enabled).
•
Status Error code 1 (motion)
•
Status error code 2 (A/D error)

•
0x64 (100 decimal): CAL LOW CMD
. Write a 0x64 hex to the command register to
perform the low step of a traditional calibration. The status register will read 0 if this
command succeeds:
•
Calibration_Fail 1
•
Calibration_Fail_Motion 3
•
Calibration_Fail_Adc_Error 4
•
During a Cal Low Command: Code 2 indicates "calibration in progress".

•
0x65 (101decimal): CAL HIGH CMD
. Write a 0x65 hex to the command register to
perform the high step of a traditional calibration.
•
Calibration_Fail 1
•
Calibration_Fail_Motion 3
•
Calibration_Fail_Adc_Error 4
•
HardcalFailCounts 8: not enough counts between hard cal hi and hard cal lo
•
During a Cal High Command: Code 2 indicates "calibration in progress".

•
0x66 (102 decimal): C2 CAL CMD
. Write a 0x66 hex to the command register to
perform a C2 calibration.
•
Calibration_Fail 1
•
Calibration_Fail_Motion 3
•
Calibration_Fail_Adc_Error 4
•
Calibration_Fail_Noc2 5
•
Calibration_Fail_C2capeq 6
•
Calibration_Fail_C2clones 7
•
During a C2 Cal Command: Code 2 indicates "calibration in progress".

•
0x1000 (4096 decimal): WRITE INTEGER CMD
. Set the value of an integer
parameter. Write 0x1000 in the command register 0, the parameter ID number in
registers 2, 3 and the desired value in registers 4, 5.
•
No Error Codes

•
0x1001 (4097 decimal): WRITE FLOAT CMD
. Set the value of a floating point
parameter. Write 0x1001 in the command register 0, the parameter ID number in
registers 2, 3 and the desired float value in registers 4, 5.
•
Failure 1
•
TooHigh -1 : value is above legal limit
•
TooLow -2 : value is below legal limit