GREER Company MicroGuard 510 Retrofit, Калибровка

Страница: 9 / 56

MG510R Calibration 5 W450256 Rev A 06/07
Winch Dimensions
N
Swing Offset
R
Sheave Radius
Centerline of
Rotation
Rear Winch
(1)
Front Winch
(0) J0
J1
G1
G0
H1 H0
L0
L1
Dimension “G0” and “G1” – The horizontal distance between the center of the front and rear winch
(respectively) and the center of the boom pivot.
Dimension “H0” and H1” – The vertical distance between the center of the front and rear winch
(respectively) and the center of the boom pivot.
Dimension “J0” and J1” – The distance between the top sheave and the centerline of the boom pivot
parallel to the horizontal boom plane (measurement may be identical).
Note: If the boom pivot is above the boom hoist cylinder upper pivot as shown in the illustration,
dimension “J” will be negative. Make sure to indicate a positive (+) or negative (-) value when noting
the measurement.
Dimension “L0” and “L1” – The distance between the centerline of the boom pivot perpendicular to
the horizontal boom plane and the center of the bottom sheave (measurement may be identical).
Dimension “N” Swing Offset – The horizontal distance between the center of the boom pivot and the
centerline of rotation.
Note: If the centerline of rotation is ahead of the boom pivot as shown in the illustration, the
dimension will be negative. Make sure to indicate a positive (+) or negative (-) value when noting the
measurement.
Dimension “R” Sheave Radius – The distance between the center and the outside edge of the bottom
sheave.
UsE ThE sPaCE PRovIDED IN aPPENDIx a To RECoRD ThE MEasUREMENTs.