GREER Company MicroGuard 510 Retrofit, Калибровка

Страница: 41 / 56

MG510R Calibration A-1 W450256 Rev A 06/07
appendix a - Measurement Record
Use the space provided below to enter the necessary dimensions. Dimensions must be entered into
the system in feet and tenths of a foot. Please make sure to convert any measurements if necessary
before recording them.
Callout Description Measurement
Boom Pivot Dimensions (see page 4)
l
The horizontal distance between the center of the boom pivot and the center of
the boom hoist cylinder upper pivot.
j
The vertical distance between the center of the boom pivot and the center of the
boom hoist cylinder upper pivot. Note: If the Boom Pivot is above the boom hoist
cylinder upper pivot the dimension is or negative.
G
The horizontal distance between the center of the boom pivot and the center of
the boom hoist cylinder lower pivot.
h
The vertical distance between the center of the boom pivot and center of the
boom hoist cylinder lower pivot.
Winch Dimensions (see page 5)
G0
The horizontal distance between the center of the front winch and the center of
the boom pivot.
G1
The horizontal distance between the center of the rear winch and the center of
the boom pivot.
h0
The vertical distance between the center of the front winch and the center of the
boom pivot.
h1
The vertical distance between the center of the rear winch and the center of the
boom pivot.
j0
The distance between the top sheave and the centerline of the boom pivot
parallel to the horizontal boom plane.
j1
The distance between the top sheave and the centerline of the boom pivot
parallel to the horizontal boom plane.
l0
The distance between the centerline of the boom pivot perpendicular to the
horizontal boom plane and the center of the bottom sheave.
l1
The distance between the centerline of the boom pivot perpendicular to the
horizontal boom plane and the center of the bottom sheave.
N
Swing Offset – The horizontal distance between the center of the boom pivot and
the centerline of rotation.
R
Sheave Radius – The distance between the center and the outside edge of the
bottom sheave.