GREER Company MicroGuard 510 Retrofit, Калибровка

Страница: 10 / 56

MG510R Calibration 6 W450256 Rev A 06/07
Boom Cylinder Dimensions
M
Dimension “M” –This is the distance measured around the outside of the cylinder rod, divided by 12.
UsE ThE sPaCE PRovIDED IN aPPENDIx a To RECoRD ThE MEasUREMENTs.
span Dimensions
m
WaRNING
sETTING sPaNs oN ThE CRaNE WIll REqUIRE fUll ExTENsIoN of ThE BooM. MakE sURE
ThE CRaNE Is sET UP aCCoRDING To ThE MaNUfaCTURER’s oPERaTIoN MaNUal To
ENsURE MaxIMUM sTaBIlITy. also MakE sURE all BooM ExTENsIoNs aND loaDs aRE
lIfTED WIThIN ThE aPPRoPRIaTE loaD ChaRTs aND lIMITs. faIlURE To CoMPly WITh
MaNUfaCTURER’s lIMITs May REsUlT IN sERIoUs INjURy oR DEaTh.
Dimension “S” - This is the distance between the center of the boom pivot and the center of the
sheave with the boom fully retracted.
T
S
Dimension “T” - This is the dimension between the center of the boom pivot and the center of the
sheave with the boom fully extended.
The span of the boom is calculated by subtracting Dimension “S” from Dimension “T” (T - S = span).
UsE ThE sPaCE PRovIDED IN aPPENDIx a To RECoRD ThE MEasUREMENTs.