Chapter VII Cooling System
Great Wall Baoding Internal Combustion Engine
Manufacturing Company Limited
427
Fig. 7-2-35 Installing the radiator assembly
Fig. 7-2-36 Installing the overflow tank hose
23 N•m ± 3 N•m
(2) Connect the radiator fan and the harness
terminals.
Caution:
Do not let the fan vanes scratch the
radiator core during installation.
Installing the lower water rubber hose of radiator
③
(1) Install the lower water rubber hose of radiator to
the engine water port and radiator water port.
(2) Tighten the clips at both ends of the lower water
rubber hose of radiator
Installing the upper water rubber hose of radiator
②
(1) Connect the upper water rubber hose of radiator to
the radiator.
(2) Install the clip at the connection point between the
upper water rubber hose of radiator and the radiator,
and tighten the clip. See Fig. 7-2-35.
Installing the overflow tank rubber hose
①
(1) Fit the overflow tank hose to the overflow tank, and
clamp the hose by a clip as shown in Fig. 7-2-36.
(2) Add the qualified coolant until to the neck of the
radiator filling hole and to the MAX mark of the
overflow tank.
After installation, perform the following steps:
(1) Connect the earthing cables of storage battery.
(2) Fill coolant into the cooling system. Coolants of
different grades can not be mixed to use, since the
preservatives selected may differ from each other. So,
pay attention to the grade of the coolant which has
been added.
(3) Start and warm up the engine.
(4) Check the level of engine coolant.
(5) Check whether there is any leakage in the cooling
system.
Upper water
rubber hose
Lower water
rubber hose
Fan assembly
Overflow tank
hose
