GRASS VALLEY KARRERA, Инструкция по установке и обслуживанию

Страница: 351 / 389

Installation & Service Manual
327
12.X to 14.3 Upgrade: Install IP Board ARM Software
Result:
HAD Flashing Success! 8 Passed, 0 failed
6 Once the programming is completely finished, power cycle the Frame to complete the
HAD update process.
7 To verify the update, enter checkHADs at the prompt:
->checkHADs
Result:
HADs up-to-date:
value = 1 = 0x1
HADs out-of-date:
value = 0 = 0x0
(followed by a list of out-of-date HADs)
-> checkHADs
value = 1= 0x1
->
12.X to 14.3 Upgrade: Install IP Board ARM Software
GV K-Frame XP IP systems with switcher software version 12.x.x require an upgrade to the
latest IP I/O Board ARM software when installing 14.3.x software. Upgrade the ARM
software using either a serial connection or SSH session.
NOTE: The default username for an SSH connection is “user” and the default
password is “gvuser”.
Note: Starting with switcher software version 14.0.0, Board ARM
Software upgrades for IP I/O boards are no longer required; the
process has been automated.
1 Using the GV K-Frame XP Installer, install the 14.3.1 software (see the Kayenne/Karrera/GV Korona
Release Notes for specific instructions).
2 Open the Frame door and attach the serial console cable to the front edge of the
Controller board. Upgrade or Verify that the board FPGA HADs are up to date.
3 To check the HAD status, enter checkHADs at the prompt:
->checkHADs
Result:
HADs up-to-date:
value = 1 = 0x1
HADs out-of-date:
value = 0 = 0x0
1 If the HADs are out of date, continue to the next steps.
2 Enter the console menu by typing consoleMenu at the prompt:
CAUTION: Do not power down or reset the Frame during the update
process, HAD programming takes several minutes to
complete.