Validate Incoming Messages
Choose whether the incoming messages will be validated or not.
The default setting is “No”.
Omit charset=UTF-8 in MESSAGE
Omit charset=UTF-8 in MESSAGE content-type.
The default setting is “Disabled”.
Allow Unsolicited REFER
Allow Unsolicited REFER to accomplish an outgoing call.
●
Disabled
●
Enabled
●
Enabled/Force Auth
The default setting is “Disabled”.
Accept Incoming SIP from Proxy Only
When set to “Yes”, the SIP address of the Request URL in the incoming SIP
message will be checked. If it doesn’t match the SIP server address of the
account, the call will be rejected.
The default setting is “No”.
Check SIP User ID for Incoming
INVITE
If set to “Yes”, SIP User ID will be checked in the Request URI of the incoming
INVITE. If it doesn’t match the phone’s SIP User ID, the call will be rejected.
The default setting is “No”.
Allow SIP Reset
This is used to perform a factory reset through SIP NOTIFY. When the phone
receives the NOTIFY with Event: reset, the phone should perform a factory
reset after the authentication. The default setting is “No”.
Authenticate Incoming INVITE
If set to “Yes”, the phone will challenge the incoming INVITE for authentication
with SIP 401 Unauthorized response
Default setting is “No”.
MOH
On Hold Reminder Tone
If set to “Enabled”, phone will play a reminder tone when it has a call on hold.
The default setting is “Enabled”.
Music On Hold URI
Configures Music On Hold URI to call when a call is on hold. This feature must
be supported on the server side.
Advanced Features
Special Feature
Different soft switch vendors have special requirements. Therefore, users may
need select special features to meet these requirements. Users can choose
from Standard, Nortel MCS, Broadsoft, CBCOM, RNK, Sylantro, Huawei IMS,
PhonePower and UCM Call center depending on the server type. The default
setting is “Standard”.
Feature Key Synchronization
This feature is used for Broadsoft call feature synchronization. When it’s
enabled, DND, Call Forward features and Call Center Agent status can be
synchronized between Broadsoft server and phone. Default is “Disabled”.
Conference URI
Configures Conference URI for N-way conference (Broadsoft Standard).
Broadsoft Call Center
When set to “Yes”, a Softkey “BSCCenter” is displayed on LCD. User can
access different Broadsoft Call Center agent features via this Softkey.
Please note that “Feature Key Synchronization” will be enabled regardless of
this setting. Default setting is “Disabled”.
Note: To activate this feature, users need to change the special feature to
Broadsoft and setup the Broadsoft Call Center to take effect.
