Page
•
globalcontract.com
7
• Summer 2017
GLOBAL
Contract
INSTALLATION GUIDELINES
2
1
4
3
A
Storage table beam’s fl exibility allows for a single table application (with the table
leg tucked in under the work surface) as well as for a double table installation
(two adjacent tables supported by a shared leg in the middle (
A)
and two storage
cabinets at the opposite ends).
STEP 1: Position beam’s end bracket over leg’s horizontal, rectangular tube. Use
Allen key to secure top and bottom bracket ends with two supplied screws.
Level the whole assembly.
STEP 2: Turn the work surface upside down on a smooth surface and secure it to
the leg/beam subassembly with supplied screws.
STEP 3: Mount two L brackets to the side of Storage tower. Drive two supplied
machine screws through the brackets into threaded inserts embedded in the stor-
age tower side panel.
STEP 4: Place the Storage tower in its fi nal location and position the leg/beam/
work surface assembly so that the work surface rests on the installed L brackets.
Ensure that the work surface and the tower are aligned.
Secure the work surface to the L brackets with supplied screws.
Storage Table Beam
Storage table beam adapter allows a work surface to be supported by a leg on
one side and a spine storage cabinet on the opposite side. A typical Storage
spine is formed by series of interconnected 21” or 25” high storage cabinets of
corresponding depth.
The Storage beam is connected to a single or Back 2 Back leg on one side and to
the work surface on the opposite side - thus saving one leg assembly.
The 21” or 25” adapters provide structural support - acting as supports between
top of the storage cabinet spine and the bottom of perpendicular work surfaces.
The fl exible leg/beam/adapter assembly arrangement allows the leg to be tucked
in under the work surface or to be shared by two adjacent work surfaces.
Included hardware connects the adapter to the worksurface and to the storage
table beam.
STEP 1: Position beam’s end bracket over leg’s horizontal, rectangular tube. Use
Allen key to secure top and bottom bracket ends with two supplied screws.
STEP 2: Attach Spine / Storage table beam adapter to the Storage table beam. Use
Allen key and the supplied screw to secure.
STEP 3: Turn the work surface upside down on a smooth surface and secure it to
the leg/beam/adapter subassembly with supplied screws.
STEP 4: Rest the leg/beam/adapter/work surface assembly on top of the storage
spine. Adjust to the desired position.
STEP 5: Mark the position of the Adapter holes on the top surface of the support-
ing storage cabinet.
STEP 6: Use 3/8” or 10mm diameter drill bit to drill two holes as marked.
STEP 7: Use Allen key to hold special 3/4” (19mm) long supplied screw inside of
the Storage adapter.
STEP 8: Use 5mm Allen key to secure the Storage adapter to the storage cabinet
top with supplied fastener as illustrated.
Storage Table Beam Adapter
3
1
2
4
7
8
5
6
