•Page
globalcontract.com
12
• Summer 2017
GLOBAL
Contract
INSTALLATION GUIDELINES
A
A
B
B
STEP 1: Install four brackets (two pairs of left and right brackets are required). Below
work surface Power troughs are provided with 4 pairs of mounting holes to accom-
modate the brackets at various table leg positions.
Back 2 Back two person pod tables use narrower supporting beams and the legs on
both sides are, therefore, inset below work surfaces. To fi t the Trough and brackets
into this narrower space use a pair of mounting holes “B - B” to secure below work
surface Power Trough to a single assembly of two of Back 2 Back tables.
A Back 2 Back table assembly at the beginning of a multiple table run employs slightly
longer supporting beams to accommodate the legs on the ‘start of a run’ side to be
inset below work surfaces, and the shared leg to be right below the seam of two
adjacent work surfaces. Use a pair of mounting holes “B” to secure brackets to the
Power Trough on the ‘start of a run’ side, use the pair of mounting holes “A” to secure
brackets to the Power Trough on the ‘shared’ leg side.
A Back 2 Back table assembly in the middle of a multiple table run employs the lon-
gest, interconnecting supporting beams - placing shared legs right under the seams
of adjacent work surfaces on both sides.
Use mounting holes “A” on both sides to secure brackets to the Power Trough.
Position the Power Trough over the brackets so that threaded studs on the brackets pro-
trude through the holes in the Power Trough. Secure brackets with supplied thumb nuts.
NOTE: Ensure that Trough ends are equidistant from worksurface ends.
Below Worksurface Power Trough Installation
Below Worksurface Power Trough Installation
STEP 2: Engage Trough’s brackets with the leg’s horizontal beam. Ensure that tab “D”
fi ts over the leg beam. Use tab “E” to locate the bracket against the leg work surface
bracket as illustrated.
STEP 3: Secure each bracket by driving supplied screws through tab “C” into the
bottom of the work surface.
2
D
C
E
3
NOTE: the brackets illustrated
supporting the Trough in
extended posistion for
SHARED LEG
Power Trough - 120° Installation
Installation of 120º Power Troughs and Below work surface Power Troughs on a
work surface supported by storage Towers.
120º Power Troughs and Power Troughs on a work surface supported by storage
Towers are secured to tables with two types of brackets: the standard trough-
mounting brackets on one side (the same, above described rules apply: (
A)
posi-
tion for shared application; (
B)
position for end of a run application) and narrow
”Z” brackets securing the opposite side of the Power Troughs in the proximity of
the 120º ‘corner’ leg or in the proximity of Storage Tower.
STEP 1: Install trough brackets
STEP 2: Preassemble “Z” brackets and power Troughs: Thread the threaded stud
through the Power Trough as illustrated. (Notch in the front edge of the Power
Trough prevents the “Z” bracket from rotating).
STEP 3: Engage Trough’s brackets with the leg’s horizontal beam. Ensure that tab
“A” fi ts over the leg beam. Use tab “B” to locate the bracket against the leg work
surface bracket as illustrated.
STEP 4: Secure the Trough by driving supplied screws through tab “C” and
through “Z” brackets into the bottom of work surfaces.
1
2
4
3
