•Page
globalcontract.com
2
• Summer 2017
GLOBAL
Contract
Bridges 2 Installation Sequence
NOTE: Although some illustrations depict round legs and some rectangular legs, the
leg-to-beam and leg-to-work surface assembly is the same.
STEP 1: LAYOUT ORIENTATION
Orient the layout plan within the installation area, determine the location of table
assemblies, power source and main storage components; establish the highest point
on the fl oor.
STEP 2: SUPPORTING STRUCTURE - legs, supporting beams
Identify type and size of required components and position them in accordance with
layout plans. Proceed with connecting legs and structural beams (see the following
pages for detailed instructions). Make sure that all rails are leveled and securely con-
nected before proceeding with installation of worksurfaces.
STEP 3: WORKSURFACES
STEP 4: ACCESSORIES - task and paper organizers
Determine type and location of accessories as specifi ed in fl oor plans. Pro-
ceed with installation of accessories.
STEP 5: STORAGE
STEP 6: ELECTRICS and DATA / COMMUNICATION - cable routing; cable manage-
ment
Connect power feed harness to building power supply; check circuit assignments and
functionality of power delivery at each duplex receptacle.
STEP 7: WALK THROUGH / INSTALLATION INSPECTION
INSTALLATION GUIDELINES
Beam Applications
Bridges2 table Legs are connected with supporting beams. Unless noted there is
one beam for a single line of tables while two beams connect Back 2 Back table
structures. Adjustable clamps at either end of the beam can be adjusted to ac-
commodate the following applications in both single table as well as Back 2 Back
table confi gurations.
STANDARD TABLE BEAM
Single table beam application
bridges two legs to form support for a single
table, or two Back 2 Back work surfaces.
Adjustable clamps at either end of the beam are pushed all the way in to allow
both table legs to be tucked under the work surface.
End of run table beam
application
supports one table leg assembly tucked
under work surface (one adjustable clamp pushed all the way in), while the other
table leg assembly can be shared between two adjacent work surfaces (adjust-
able clamp pulled out to extend the beam).
Interconnecting table beam
application
supports both table leg assemblies ex-
tended to support adjacent work surfaces on either side. Both adjustable clamps
pulled out to extend the beam at either end.
TELESCOPIC TABLE BEAM
Supports a return connected perpendicularly to a 24” or 30” deep primary work
surface. The Telescopic beam is connected to a single or Back 2 Back leg on one
side and to any work surface-supporting beam on the opposite side. Telescopic
beam clamp allows the table leg to be tucked under worksurface or shared
between two adjacent worksurfaces.
STORAGE TABLE BEAM ADAPTER
Connects to Storage table beam. This assembly allows a work surface to be
supported by a leg on one side and a spine (formed by interconnected storage
cabinets) on the opposite side.
STORAGE TABLE BEAM
The Storage beam is connected to a single or Back 2 Back leg on one side and
to the work surface on the opposite side - thus saving one leg (assembly work
surface is connected to storage units with included storage brackets). Storage
table beam’s fl exibility allows for a single table application (with the table leg
tucked in under the work surface) as well as for a double table installation (two
adjacent tables supported by a shared leg in the middle and two storage cabinets
at the opposite ends).
